MT2834ZPX Owner's Manual
S-Registers
Certain Command Mode configurations are stored in memory registers called, S-Registers. The S command is used to assign a value to, and to read the current value of an S-Register. To assign a value to an S- Register, enter the letter S, followed by the S-Register number and an equals sign (=). To read an S-Register value, enter the letter S followed by the S-Register number and a question mark (?), then hit RETURN. To verify that the S-Register value was entered correctly, enter for example, ATS8? and hit RETURN. You should receive a response of the assigned value given to that S-Register.
S0
Number of Rings Until Modem Answers
Unit: | 1 ring |
Range: | 0-255 |
Default: | 0 |
Description: Sets the number of rings before the modem answers.
S1
Rings Which Have Occurred
Unit: 1 ring Range: 0-255 Default: 0
Description: Counts the number of rings that have occurred.
S2
Escape Code Character
Unit: ASCII Character
Range: 0-127
Default: 43 (+ sign)
Description: Defines the escape code character.
