Multi-Tech Systems MT5634ZPX-PCI DS=n Dial Stored Telephone Number, Echo Command Mode Characters

Owner’s Manual

@Wait for quiet answer. Causes modem to wait for a

ringback, then 5 seconds of silence, before processing next part of command. If silence is not detected, the modem returns a NO ANSWER code.

$AT&T’s call card tones detection.

^Disable data calling tone transmission.

Command:	DS=n	Dial Stored Telephone Number
Values:		n = 0–3
Default:		none
Description:		Dial a number previously stored in directory number n by
		the &Zn=x command .
		Example: ATDS=3
Command:	En	Echo Command Mode Characters
Values:		n = 0 or 1
Default:		1
Description:	E0	Do not echo keyboard input to the terminal.
	E1	Do echo keyboard input to the terminal.
Command:	Fn	Echo Online Data Characters
Values:		n = 1
Default:		1
Description:	F0	Enable online data character echo. (Not supported.)
	F1	Disable online data character echo (included for backward
		compatibility with some software).
Command:	Hn	Hook Control
Values:		n = 0 or 1
Default:		0
Description:	H0	Go on-hook to hang up.
	H1	Go off-hook to make the phone line busy.
Command:	In	Information Request
Values:		n = 0–4, 9, 11
Default:		None
Description:	I0	Display default speed and controller firmware version.
	I1	Calculate and display ROM checksum (e.g., 12AB).
	I2	Check ROM and verify the checksum, displaying OK or
		ERROR.
	I3	Display default speed and controller firmware version.

36 MT5634ZPX-PCI