Multiquip C30HDZ manual Control BOX Components, Pump Control Box Components

CONTROL BOX COMPONENTS

Figure 8 illustrates the location of the major components for the C30HDZ Control Box. The function of each component is described below:

2

3

5

7

4

6

8

1

Figure 8. Pump Control Box Components

1. Throttle Control Knob – This is a variable speed type control. Turning the throttle lock left (CCW) unlocks the throttle allowing the throttle control cable to be pulled out to the desired position. Once the desired engine speed has been achieved, turning the throttle lock to the right (CW) locks it in place. Use the fine tune adjustment knob to fine tune the engine rpm's.

To place the engine in idle, press the top button inward all the way.

ALWAYS unlock the throttle control

NOTE before it is pushed in because if this is not done first, possible damage could result to the locking mechanism.

2. Oil Pressure Indicator Lamp – In the event of low oil in the engine crankcase or low oil pressure, the indicator lamp will illuminate.STOP the engine immediately if this occurs. NEVER run the engine when this lamp is lit.

3.Battery Charge Indicator Lamp – Indicates if the electrical system is charging properly. If the Battery Charge Indicator Lamp is lit, this is an indication that the charging system is malfunctioning. STOP the engine and remedy the electrical charging problem.

4.WaterTemperature Lamp – Indicates high engine water temperature (220 degrees Fahrenheit) this lamp will be lit. STOP the engine immediately if this lamp comes on.NEVER run the engine when this lamp is on.

5.Pumping Control Switch – This 3-position switch controls the pumping of the pump.The left most position is for use with the remote control unit, the center position is for normal pumping operation, and the right most position (OFF) prevents pumping.

6.Remote Control Input Connector – Insert the remote control input cable into this connector.

7.Ignition Switch – Insert the ignition key here to start the engine. Turn the key clockwise to the ON position, then continue turning clockwise to the START position and release. To stop the engine turn the key fully counter- clockwise to the STOP position.

8.Hourmeter– Display's the number of hours the pump has been in use.

PAGE 24 — MAYCO C30HDZ PUMP — OPERATION AND PARTS MANUAL — REV. #12 (04/03/12)