Multiquip C30HDZ manual Following procedure will assist you in replacing the lining

MAINTENANCE (PUMP)

Clutch Lining Replacement

(For P/N EM14320 Clutch Assembly Only)

The normal lining thickness measures 3/16 of an inch. If the clutch starts to slip or make an usual noise, it may be necessary to replace the lining. Please note that the lining retaining rivets should not be exposed to the rotating weight.

The following procedure will assist you in replacing the lining.

1.Removewornoutliningandrivets.Checkclutchspringsand flyweights for wear.

2.Cut 1/8 in. off of each end of clutch lining. Slide lining into place.Insert one rivet into clutch lining hole.(Make sure rivet goesfrominsideout.)Wedgeaflatheadscrewdriverbetween clutch flyweight and rivet head.

3.Adjust screwdriver so that the rivet sticks out from the clutch housing approximately 1/8 of an inch.With a flat punch, pen the ends on the rivet so that it locks in place with the clutch housing.Repeatthisprocedureforallremainingclutchrivets.

The clutch lining is a normal

NOTE maintenance item and will require periodic replacement.

PAGE 40 — MAYCO C30HDZ PUMP — OPERATION AND PARTS MANUAL — REV. #12 (04/03/12)