Multiquip DCA85usJ2 manual Faults and Warning, Auxiliary Gage Fault

DIAGNOSTIC DISPLAY

2.The main menu will pop up on the display. Use the “Arrow Buttons” to scroll through the menu until the “Engine Configuration” menu item has been highlighted

.

GO TO 1-UP DISPLAY

STORED CODES

ENGINE CONFG

SETUP 1-UP DISPLAY

SETUP-4-UP DISPLAY

SELECT UNITS

ADJUST BACKLIGHT

FAULTS AND WARNING

Auxiliary Gage Fault

1.During normal operation the single or four parameter screen will be displayed.

				98%	1000 RPM
0			3000	LOAD RPM	ENG RPM
	1500
	1800 RPM
				14.2	57 PSI
ENG RPM		COOL TEMP		BATT VOLT	OIL PRES

3.Once the “Engine Confi guration” menu item has been highlighted touch the “Enter Button” to view the engine confi guration data.

GO TO 1-UP DISPLAY

STORED CODES

ENGINE CONFG

SETUP 1-UP DISPLAY

SETUP-4-UP DISPLAY

SELECT UNITS

ADJUST BACKLIGHT

4.Use the “Arrow Buttons” to scroll through the engine confi guration data.

ENGINE SPEED PT 1

1800 RPM

MORE

5. Touch the “Menu Button” to return to the main menu.

ENGINE SPEED PT 1

1800 RPM

MORE

6.Touch the “Menu Button” to exit the Main menu and return to the engine parameter display.

2.The PVA Series of auxiliary gages can be attached to the PowerView. These auxiliary gages communicate with the Modbus master PowerView via a daisy-chained RS-485 port. If at any time during system initialization or normal operation an auxiliary gage should fail, the single or four parameter screen will be replaced with the “MLink Gage Fault” message.

1 of x

ENGINE OIL PRESSURE

GAGE NOT RESPONDING

HIDE

3.To acknowledge and “Hide” the fault and return to the single or four parameter display, touch the “Enter Button.

1 of x

ENGINE OIL PRESSURE

GAGE NOT RESPONDING

HIDE

4.The display will return to the single or four parameter screen.

				!	98%		1000 RPM
0	1500		3000
	1800 RPM				LOAD RPM		ENG RPM
						!
		COOL TEMP!			14.2		57 PSI
ENG RPM
					BATT VOLT		OIL PRES	!

DCA85USJ2 60 HZ GENERATOR • OPERATION AND PARTS MANUAL — REV. #1 (03/22/11) — PAGE 23