Multiquip DCA85usJ2 Setup 4-Up Display, Select the 4-Up Custom Setup from the 4-Up Setup menu

DIAGNOSTIC DISPLAY

Setup 4-Up Display

1.From the single or four engine parameter display touch the “Menu Button

			98%	1000 RPM
0		3000	LOAD RPM	ENG RPM
	1500

1800 RPM

		14.2	57 PSI
ENG RPM	COOL TEMP	BATT VOLT	OIL PRES

2.The main menu will pop up on the display. Use the “Arrow Buttons” to scroll through the menu until the “Setup 4-Up Display” is highlighted.

GO TO 1-UP DISPLAY

STORED CODES

ENGINE CONFG

SETUP 1-UP DISPLAY

SETUP-4-UP DISPLAY

SELECT UNITS

ADJUST BACKLIGHT

5.The “Use Defaults” screen will be displayed during the resetting period then will automatically return to the “Setup 4- Up Display” menu.

RESTORED TO

DEFAULTS

6.Select the “4-Up Custom Setup” from the “4-Up Setup” menu.

USE DEFAULTS

CUSTOM SETUP

3.Once the “Setup 4-Up Display” menu item has been highlighted touch the “Enter Button” to activate the “Setup 4- Up Display” menu.

7.The quadrant with the backlit parameter value is the current selected parameter. Use the “Arrow Buttons” to highlight the parameter value in the quadrant you wish to place a new parameter.

GO TO 1-UP DISPLAY STORED CODES ENGINE CONFG SETUP 1-UP DISPLAY

SETUP-4-UP DISPLAY SELECT UNITS ADJUST BACKLIGHT

USE DEFAULTS

CUSTOM SETUP

4.Touch the “Enter Button” to activate the “Use Defaults” function. This action will reset the unit to the factory default.

USE DEFAULTS

CUSTOM SETUP

AUTOMATIC SCAN OFF

8.Touch the “Enter Button” and a list of parameters will appear.

125°F	1000 RPM
COOL TEMP	ENG RPM

14.257 PSI

BATT VOLT OIL PRES

PAGE 30 — DCA85USJ2 60 HZ GENERATOR • OPERATION AND PARTS MANUAL — REV. #1 (03/22/11)