DIAGNOSTIC DISPLAY
11.Touch the “Menu” button to return to “Utilities” menu. Touch the “Menu button again to return to the “Main” menu.
STORED CODES
ENGINE CONFG
SETUP
SELECT UNITS
ADJUST BACKLIGHT
UTILITIES
4.Use the “Arrows” to scroll down to and highlight either the “Slave Active or Master Active” modes. Touch the “Enter” button to toggle between master and slave.
USE FACTORY DEFAULT
SERIAL PORT SETUP
SOFTWARE VERSION
SLAVE ADDRESS SETUP
MASTER ACTIVE
MODBUS SETUP
1.Starting at the single or four engine parameter display, touch the “Menu Button”.
|
|
|
|
|
| 98% | 1000 RPM | ||
|
|
|
|
|
| ||||
0 |
|
|
| 3000 | LOAD RPM | ENG RPM | |||
1500 | |||||||||
| 1800 RPM |
|
|
|
| ||||
|
|
|
|
| |||||
|
|
|
|
|
| 14.2 | 57 PSI | ||
ENG RPM | COOL TEMP | BATT VOLT | OIL PRES | ||||||
|
|
|
| ||||||
|
|
|
|
|
|
|
|
|
|
2.The main menu will be displayed. Use the “Arrow Buttons” to scroll through the menu until the “Utilities” is highlighted, then touch “Enter”.
STORED CODES
ENGINE CONFG
SETUP
SELECT UNITS
ADJUST BACKLIGHT
UTILITIES
5.Use the “Arrows” to scroll to the “Serial Port” menu to highlight it, then touch “Enter”.
USE FACTORY DEFAULT
SERIAL PORT SETUP
SOFTWARE VERSION
SLAVE ADDRESS SETUP
MASTER ACTIVE
6.Use the “Arrow” button to scroll to each selection to confi gure the MODBUS values for your application.
BAUD RATE
PARITY
DATA BITS
STOP BITS
7. When fi nished, touch “Menu” to return to the previous screen.
3.Once in the “Utilities” menu use the “Arrows” to scroll through the menu until the “Modbus Setup” menu is highlighted, then touch “Enter”.
GAGE DATA
REMOVE ALL GAGES
SOFTWARE VERSION
MODBUS SETUP
FAULT CONVERSION
DCA85USJ2 60 HZ GENERATOR • OPERATION AND PARTS MANUAL — REV. #1 (03/22/11) — PAGE 33
