Just in case
Printouts have irregularities
The paper you’re using may have absorbed moisture, per-
haps due either to high humidity or water ha ving been
spilled on the paper supply. Toner will not adhere well to
wet paper.
Replace the paper with dry paper and try printing again.
Printouts have white and/or black lines
The toner cartridge or drum cartridge may be defective .
Remove the cartridges and check them for damage.
If the problem persists, replace either or both of the car-
tridges as indicated.
The LED print head may be dirty.
Using the cleaning paper, gently clean the LED print head.
The charger may be dirty.
Your machine normall y cleans the charger automatically.
If other solutions fail, please contact your authorized
Muratec dealer.
Printouts have black lines or multiple streaks
The toner cartridge may have been stored improperly.
Try following procedure to clear up the problem:
1Press
COPY
/
FAX
to change to the copy mode.
2If there is a document in the
ADF
or
FBS
, remove it.
3Open the book-cover fully.
4Press
START
to make a black copy.
Printouts have toner smudges
The toner may be unevenly distributed inside the toner
cartridge.
Remove the toner cartridge and shake it a few times to
redistribute the toner inside. If the problem persists, replace
the cartridge.
The toner cartridge or drum cartridge may be defective .
Remove the cartridges and check them for damage. If the
problem persists, replace either or both of the cartridges as
indicated.
If you find smudges on the back of the printouts, the trans-
port roller may be dirty.
Your machine normall y cleans the transport roller automat-
ically. If other solutions fail, please contact your authorized
Muratec dealer.
Printouts have white spots
The charger may be dirty.
Your machine normall y cleans the charger automatically.
If other solutions fail, please contact your authorized
Muratec dealer.
ABCDE
ABCDE
ABCDE
ABCDE
ABCDE
ABCDE
ABCDE
ABCDE
ABCDE
ABCDE
ABCDE
ABCDE
ABCDE
ABCDE
ABCDE
ABCDE
ABCDE
ABCDE
ABCDE
ABCDE
5.7
J ust in Case Getting Started