Muratec MFX-2530 Combine

Advanced Copy

Combine

You can copy 2, 4 or 8 pages of your documents into one sheet.

2 pages --> 1 sheet 4 pages --> 1 sheet

8 pages --> 1 sheet

Note: If you select the 2 in 1 or 8 in 1, you should set your document with the dif-

ferent direction from the direction of recording paper you selected.

If you select the 4 in 1, you should set your document with the same direc-

tion from the direction of recording paper you selected.

Note: You can print a separator line between copied images .

Note: In this mode, the reduce/enlarge ratio will be set to “Auto” (automatically).

If you want to set the reduction/enlargement ratio manually, set the ratio

after setting the combine function.

Note: According to the size of document and recording paper you selected, a part

of the image might be lacked.

Note: If the number of the documents you set was less than document pages you

selected for combining, the last page(s) will be copied blank.

Note: The machine cannot copy your documents different in size and direction.

Make sure the document are set to same direction shown on the LCD.

Note: You cannot use this function with the duplex function.

To copy with combining:

1Press

2Select “Combine” using the cursor key, and then press [Enter].

Note: The Auto Reduce/Enlarge is selected automatically.

3Select the desired combination modes using the

cursor key.

Note: The number of documents combined

can be 2, 4 or 8.

4If you want to change the recording paper size

for combining, proceed to next step. Otherwise,

skip to step 6.

5Press [Paper] to select the paper size, and then press [Enter].

6You can insert the separator lines between combined images . If you want to

insert the separator lines, proceed to next step. Otherwise, skip to step 8.

7Press

and then press [Line] to print the

separator lines. To cancel the separator lines,

press [Line] again.

Note: The width of the line can be changed.

(See page 2.28.)

8If you want to arrange the position of the each

document, proceed to next step. Otherwise, skip to step 12.

9Press [Position], the

LCD

will show:

Note: If [Position] does not appear on the

LCD

, press

10 Select the position using the cursor key and

enter the number of the document you want to

change using the numeric keypad.

Note: The number which was on the position you selected will change places

with the number you entered.

Note: If you want to reset to the initial position setting, press [Again].

11 Press [Enter] to save the setting.

Muratec MFX-2530 manual Combine

Combine

2 pages --> 1 sheet 4 pages --> 1 sheet

8 pages --> 1 sheet

2.10