N-Tron 7014FX2, 7014TX, 7014FXE2 28/2007 115, Create Trunk, Delete Trunk, Show Trunk Information

Create Trunk

Command Name	trunk create
Description	To create a trunk. A trunk is used to get more bandwidth to withstand high
	traffic.
Syntax	trunk create <port-list> [-name <trunk-name>]
Parameters	port-list
		Port numbers to be added to the trunk.
	trunk-name
		Name given to a trunk
Examples	N-TRON/Admin#[1]> trunk create 4-7 –name trunk1
NOTES	RSTP must be disabled in order to use Trunking. Only 1 trunk can be
	created per switch. A maximum of 4 ports can be in a trunk. All trunk
	ports must be at the same speed and duplex mode. If a port is not linked,
	there could be difficulty matching similar speed and duplex mode. It is best
	to hard code speed and duplex mode for each trunking link, at both ends.
Delete Trunk
Command Name	trunk delete
Description	To delete the trunk .
Syntax	trunk delete
Parameters
Examples	N-TRON/Admin#[1]> trunk delete
	Trunk has been deleted.
NOTES
Show Trunk Information
Command Name	trunk show
Description	To show all the trunks information.
Syntax	trunk show
Parameters	None
Examples	N-TRON/Admin#[1]> trunk show
	------------------------------------------------
		TRUNK NAME	TRUNK PORTS	TRUNK STATE
	------------------------------------------------
		trunk1	3-5	DISABLE
	------------------------------------------------
NOTES

6/28/2007 page 115 of 145