Testing the System
Page 10 | WI1501A 9/06 |
TESTING THE SYSTEM |
|
After installation is completed, test the system as follows. |
|
1.Call the central station to inform them of the test.
2.Initiate an alarm, preferably on a zone that activates a steady siren, and verify proper signalling.
3.Call the central station to confirm their receipt of a good transmission.
Note: Be sure to test all enabled Touchpad panics.
Signal Strength Testing/Wireless Systems
To test the operation of wireless transmitters, proceed as follows.
1. | Enter the | |||
2. | Fault a point of the transmitter to be tested by opening the loop. If the signal strength of the | |||
transmitter is 3 or greater, the Touchpad will beep, as follows: | ||||
|
|
|
|
|
|
| Signal Power | Beeps | |
|
| 0 |
| |
|
| 3 | 1 |
|
|
| 2 |
| |
|
| 3 |
| |
|
| 4 |
| |
3. | Restore the wireless point (close the loop). |
The transmitter signal strength will be displayed on a scale of
Freedom | L NAPCO Security Systems |
|