National Instruments Ultiboard Working with Part Groups

Chapter 3 Setting Up a Design
© National Instruments Corporation 3-13 NI Ultiboard User Manual
8. Click checkboxes beside the desired nets in the Assign Nets list and
click Apply to add them to the group.
Note You cannot assign a net to more than one group. Therefore, nets that are already
assigned to another net group do not appear in the Assign Nets list.
9. Click OK to close the Edit Groups dialog box.
Complete the following steps to edit a net group:
1. Select Tools»Group Editor to di splay the Edit Groups dialog box.
2. Select the Net Groups tab.
3. Highlight the desi red group in the Groups list.
4. Change the net assignments as desired and click Apply.
5. Optionally, highlight the desired group in the Groups list and click the
Properties button to display the Change group settings dialog box.
6. Make the required changes in the Group Settings area and click OK.
Note Refer to the Change Group Settings dialog box and Net Group Settings sections for
more information.
Complete the following steps to delete a group:
1. Select Tools»Group Editor to di splay the Edit Groups dialog box.
2. Select the Net Groups tab.
3. Highlight the desi red group in the Groups list and click Delete.
Working with Part Groups
Complete the following steps to create a part group:
1. Select Tools»Group Editor to di splay the Edit Groups dialog box.
2. Click the Part Groups tab.
3. Click Add. The Add group dialog box appears.
4. Enter the desired name and click OK. The Change group settings
dialog box appears.
5. Change the settings in the Group Settings area as desired.
Note Refer to the Change Group Settings dialog box and Part Group Settings sections for
more information.