National Instruments Ultiboard Change Group Settings dialog box

Chapter 3 Setting Up a Design
NI Ultiboard User Manual 3-18 ni.com
8. Click two checkboxes beside the desired nets in the Assign Nets list
and click Apply to add them to the group.
Note You cannot assign a net to more than one differential pair. Therefore, nets that are
already assigned to another differential pair do not appear in the Assign Nets list.
9. Click OK to close the Edit Groups dialog box.
Complete the following steps to edit a bus group:
1. Select Tools»Group Editor to di splay the Edit Groups dialog box.
2. Select the Differential Pairs tab.
3. Highlight the desi red group in the Groups list.
4. Change the net assignments as desired and click Apply.
5. Optionally, highlight the desired group in the Groups list and click the
Properties button to display the Change group settings dialog box.
6. Make the required changes in the Group Settings area and click OK.
Note Refer to the Change Group Settings dialog box and Differential Pair Settings
sections for more information.
Complete the following steps to delete a group:
1. Select Tools»Group Editor to di splay the Edit Groups dialog box.
2. Select the Differential Pairs tab.
3. Highlight the desi red group in the Groups list and click Delete.
Change Group Settings dialog box
Access this dialog box from the Edit Groups dialog box. Refer to the
Working with the Group Editor section for more information.
Use this dialog box to change the group settings for net groups, part groups,
and differential pairs.
The options found in this dialog box depend on the type of group. Refer to
the following sections for more information:
•Net Group Settings
•Part Group Settings
•Differential Pair Settings