NEC 2000 manual Installing the SO-DIMM module

7.Locate an empty module slot. If you need to remove one or both modules, see “Removing a SO-DIMM Module” in the next section.

Before you install a SO-DIMM, reduce static discharge by touching a metal part on the system unit.

8.Install the SO-DIMM module as follows (see the following figure).

!Align the notch in the module with the key in the empty slot.

!Hold the module at a 45-degree angle and insert it into the slot.

!Firmly push the module into the socket.

!Press down on the edge of the module until the plastic retaining clips snap into place.

Installing the SO-DIMM module

A – SO-DIMM Module	C – Socket Key
B – Notch	D – Plastic Retaining Clip (2)

9.Install the SO-DIMM module panel and retaining screw.

10.Plug in the AC adapter power cord and press the power switch.

4-10 Adding Expansion Devices