CHAPTER 3 NDA-24318
Page 34
Issue 1
OFFICE DATA PROGRAMMING
13. When all lines of an IPTRK circuit card are busy, alternate routing to C.O. line or Tie line is available.
Details on alternate routing patterns are shown in the table below:
14. PAD can be provided for RECEIVE control only.
15. This feature does not support Broad Band Services H0, H1 of ISDN/CCIS line. This feature supports 1B
only.
16. This feature does not support any OAI/ACD services.
17. Depending to the firmware version of the IPTRK circuit card, the following system data assignment is
required. The system data varies depending on the combination of the main PBX software version and the
IPTRK firmware.
ASYDL, SYS 1, Index 527, b6: 0=PA-8IPTB (SW-404 IPTRK PROG-C) is used
1=PA-8IPTB (SW-390 IPTRK PROG-B) is used
3.4 Data Programming
To allow FCCS networking via IP [F-36] service, perform the data programming as follows:
ASYDL ACRD ACTK MBCT AFCH AETH ACAN AFRT AGIP
Note: When office data is assigned/modified, be sure to initialize the IPTRK circuit card (by flipping its MB key
OFF ON OFF).
STEP 1: ASYDL - Provided that the IPTRK circuit card is equipped in the node within the FCCS network,
NDM data broadcasting is not to be executed. Therefore, when the IPTRK circuit card is used in the
FCCS network, perform the following data assignment at the Network Control Node (NCN).
SYS1, INDEX 534, b7=1 (NDM data individual broadcasting from NCN to each LN)
Table 3-2 Alternate Routing to be Provided/Not Provided (FCCS Networking via IP [F-36])
FROM FCCS NETWORKING VIA IP
(POINT-TO-MULTIPOINT) TO FCCS NETWORKING VIA IP
(POINT-TO-MULTIPOINT)
Analog C.O. line Not Available Not Available
Analog Tie line ×Not Available
CCIS ×Not Available
ISDN × (via Sub Address-Addressing only) Not Available
Dp Channel ×Not Available
FCCS network over Intranet
(via DTI) ××
FCCS network via ISW
(IPX-U) ××
FCCS Networking via IP
(Point-to-Multipoint) ××
CCIS Networking via IP
(Point-to-Multipoint) ×Not Available
Table 3-3 PBX Software/IPTRK Circuit Card Firmware
PA-8IPTB SW-390 IPTRK PROG-B (NR-575835-000) Assign the data to 1
PA-8IPTB SW-404 IPTRK PROG-C (NR-577024-000) or later version Assign the data to 0