NDA-24318 CHAPTER 3
Page 19
Issue 1
OFFICE DATA PROGRAMMING
CHAPTER 3 OFFICE DATA PROGRAMMING
1. GENERAL
This chapter explains the procedure to assign the IPTRK circuit card-related office data, lo cated in the followin g
sections:
•CCIS Networking via IP [C-163] Required Hardware
Required Hardware (Point-to-Multipoint Connection)
Service Conditions
Data Programming
•FCCS Networking via IP [F-36] Required Hardware
Required Hardware (Point-to-Multipoint Connection)
Service Conditions
Data Programming
•PAD/EC Control Conditions
Data Programming
Note: For details on the IPTRK circuit card, refer to CHAPTER 2.
2. CCIS NETWORKING VIA IP [C-163]
This feature allows the system to use the CC IS network via the Intranet. To establish/r elease a call, the following
figure illustrates a connection pattern.
For both speech and CCIS signal channel s, an IPTRK circuit card is used. The IPTRK circuit cards in the self-
node and each of its connected nodes must be in 1-1 ratio. For additional information, see Section 2.4 Data
Programming.
When utilizing Point-to-Multipoint Connection for both speech and CCIS signal channels, an IPTRK circuit
card is used. The IPTRK circuit card accommodated in the self-node can be connected to multiple destinations
(IPTRK circuit cards of multiple nodes). For additional information, see 2.4 Data Programming.
Figure 3-1 Overview of CCIS Networking via IP [C-163]
Both Speech and CCIS Signal
Intranet
IPTRK
NEAX2400 IPXNEAX2400 IPX
IPTRK
Node A Node B
Point-to-Multipoint
Symbols:
IPTRK: IP Trunk
POWER
Router
POWER
Router