NDA-24318 CHAPTER 3
Page 27
Issue 1
OFFICE DATA PROGRAMMING
•In Point-to-Multipoint connection, because it cannot be determined which destinatio n node is to be
called until the call is originated, all of the CCIS related data is assigned for the self- node. As to th e
ACIC1 command, the data must be assigned to all the destination nodes and also to the self-node.
•Designate the Speech Path and Point Code to the assigned Outgoing Route Selection Pattern
number by using the AOPRL/AOPRN command (this is required for Point-to-Multipoint
connection only).
IPTRK (IP Trunk): 0/1=IP network is used/not used
PC (Point Code): Enter the Point Code of destination node (1-16367) Note
Note: This parameter is valid only when IPTRK=1 is selected.
•Assign the IP address to the Point Code by using the APIPL/APIPN command (this is required for
Point-to-Multipoint connection only).
PC (Point Code):Assign the Point Code of destination node (1-16367)
IP Address:Assign the IP address of the destination IPTRK (maximum of 8 addresses)
STEP 4: AGIP - Assign IP addresses of IPTRK circuit card and its connected route.
LENS (Line Equipment Number): Assign the first LEN of IPTRK-accommodated HW
block
KIND (Kind of Selection): IPTRK (CCIS)
IPTK_IP (IP Address of IPTRK): IP address of the IPTRK circuit card
DG_IP (IP Address of Default Gateway): IP address of the router
NETMSK (Net Mask of IP Address): Net Mask of IP address
ToS CONTROL: IP Precedence or DiffServ (either)
QoS1 (QoS Data for signal route): When IP Precedence is selected, 0-7
When DiffServ is selected, 0x00-0x3F
QoS2 (QoS Data for speech Path): When IP Precedence is selected, 0-7
When DiffServ is selected, 0x00-0x3F
MULT (Kind of Multiple Connection): Point-to-M ultipoint
DST_IP (IP Address of Destination IPTRK): IP address of the Destination Node IPTRK circuit card
IRT (Incoming Route): Incoming Route when Point-to-Multipoint connection
is selected Note 1
NETID (Network ID): Fixed to 0
CSLINK_NUM (Maximum number of client/server connection):16 line
ARP (Frame Type of ARP): Select DIX when the “Detail” box is checked Note 2
Note 1: When FCCS is used, assign the Logical Route Number. Assign the Route Number otherwise.
Note 2: RTP check box is provided for detail assignment of the following parameters, if required. Usually the
default data of “0” is set for all parameters.
PKGLOSS (Amount of Packet Loss): 8% (default)
JIT_MAX (Maximum Jitter Buffer): 600 ms (default)
JIT_MIN (Minimum Jitter Buffer): 80 ms (default)
MNGS (Interval of Jitter adjustment): 5 times (default )
JIT_COUNT (Interval of Jitter statistics): 1 sec (default)
BASE_COUNT (Interval of Time-base correction):10 sec (default)
JIT_FAST (Judging rate of fast arrived packet):100% (default)
TIME_FAST (Time-base correction Judgment):50% (default)