CHAPTER 3 NDA-24318
Page 40
Issue 1
OFFICE DATA PROGRAMMING
STEP 9: AGIP - Assign IP addresses of IPTRK circuit card and its connected route.
LENS (Line Equipment Number): Assign the first LEN of IPTRK-accommodated
HW block
KIND (Kind of Selection): IPTRK (FCCS)
IPTK_IP (IP Address of IPTRK): IP address of the IPTRK circuit card
DG_IP (IP Address of Default Gateway): IP address of the router
NETMSK (Net Mask of IP Address): Net Mask of IP address
ToS CONTROL: IP Precedence or DiffServ (either)
QoS1 (QoS Data for signal route): When IP Precedence is selected, 0-7
When DiffServ is selected, 0x00-0x3F
QoS2 (QoS Data for speech Path): When IP Precedence is selected, 0-7
When DiffServ is selected, 0x00-0x3F
MULT (Kind of Multiple Connection): Point-to-Multipoint Note 1
NETID (Network ID): Fixed to 0
CSLINK_NUM (Maximum number of client/server connection): 16 line
ARP (Frame Type of ARP): Select DIX when the “Detail” box is checked
Note 2
Note 1: Be sure to select “Point-to-Mult”.
Note 2: RTP check box is provided for detail assignment of the following parameters, if required. Usually the
default data of “0” is set for all parameters.
PKGLOSS (Amount of Packet Loss): 8% (default)
JIT_MAX (Maximum Jitter Buffer): 600 ms (default)
JIT_MIN (Minimum Jitter Buffer): 80 ms (default)
MNGS (Interval of Jitter adjustment): 5 times (default )
JIT_COUNT (Interval of Jitter statistics): 1 sec (default)
BASE_COUNT (Interval of Time-base correction): 10 sec (default)
JIT_FAST (Judging rate of fast arrived packet): 100% (default)
TIME_FAST (Time-base correction Judgment): 50% (default)