NEC GT6000 Introduction, 1-12, Remote Control Precautions, Remote Control Battery Installation

1. Introduction

Remote Control Precautions

•The remote control system may not function when direct sunlight or strong illumination strikes the remote control sensor of the main unit, or when there is an obstacle in the path.

•When remote control buttons are pressed and held, projector’s function keys may not operate.

•Do not subject to strong shock.

•Do not allow water or other liquid to splash on the remote control. If the remote control gets wet, wipe it dry immediately.

•Avoid exposure to heat and steam.

•Remove the batteries from the remote control when the remote control is not going to be used for a long period.

Remote Control Battery Installation

Installing the Remote Control Batteries

When it comes time to replace the batteries, two "AAA" type will be required.

1. Press and open the cover.

2.Align and insert the batteries according to the (+) and (-) indications inside the case.

Operating Range for Wireless Remote Control

The infrared signal operates by line-of-sight up to a distance of approximately 7m (20 feet) and a 60 degree angle of the remote sensor.

The projector will not function if there are objects between the remote sensor and the remote control or if strong light falls on the remote sensor. Weak batteries will also prevent the projector from operating properly.

Side View

30˚

7m

30˚

Remote sensors on the projector cabinet

7m

Remote control

NOTE: You cannot operate the projector using the remote control if:

• The remote control ID is not set to [None].

• The remote ID is not the same as the projector ID. See page 7-2 for setting remote ID and projector ID.

3. Replace the cover.

1-12