3. Projecting an Image
3.Press the 3D REFORM button on the remote control. The Cornerstone adjustment screen is displayed.
The Cornerstone adjustment screen will disappear when you move the USB mouse cursor.
4.Point to one of the remaining 3 corners and
Screen
5.Do the above step 4 for the other two corners so that the projected area becomes smaller than the screen.
Screen
When using the remote control or cabinet buttons:
1.Project an image so that the screen is smaller than the area of the raster.
2.Pick up any one of the corners and align the corner of the image with a corner of the screen.
Projected image
Screen
(The drawing shows the upper right corner.)
3.Press the 3D REFORM button on the projector or the KEYSTONE but- ton on the remote control.
6.To complete the procedure,
7.
This completes the Cornerstone adjustment.
*To return the Cornerstone adjustment to the default settings,
You can save your Cornerstone changes. The changes are saved when you turn off the projector. To do so, select [Projector Options] → [Setup] → [Page 4]. Select the 3D Reform Save check box. This is not selected at the time of shipment.
*There are limitations of shapes which can be corrected using the Cor- nerstone adjustment.
When adjusting the Cornerstone beyond these limits, you will get the mes- sage "Out of adjustment range!" and no correction can be done. Should this happen, do the Cornerstone adjustment again within the allowable range.
*Due to limitations of accuracy within internal processes, there may be some discrepancy of positions between the mouse cursor and corrected shape or one corner and the other 3 corners.
The Cornerstone adjustment screen is displayed.
NOTE: Press the 3D REFORM button to toggle between "Cornerstone" and "Key- stone."
4.Use the SELECT button to select one icon which points in the direction you wish to move the projected image frame.
Screen
5.Press the ENTER button.
6.Use the SELECT button to move the projected image frame as shown on the example.
7.Press the ENTER button.
Screen
