NEC GT6000 Installation, 2-14, To connect SCART output RGB, Connecting an External Monitor

2. Installation

To connect SCART output (RGB)

Before connections: An exclusive SCART adapter (ADP-SC1) and a commercially available SCART cable are required for this connection.

NOTE:

•Audio signal is not available for this connection.

•The RGB 1 IN connector does not support Plug & Play.

Video equipment	Projector
such as DVD player
RGB 2
	To RGB 2 IN
Commercially available Female	ADP-SC1
SCART cable

1.Turn off the power to the projector and your video equipment.

2.Use the NEC ADP-SC1 SCART adapter and a commercially available SCART cable to connect the RGB 2 input of your projector and a SCART output (RGB) of your video equipment.

3.Turn on the power to the projector and your video equipment.

4.Use the RGB 2 button on the remote control to select the RGB 2 input.

5.Press the MENU button on the remote control to display the menu.

6.From the Advanced menu, select [Projector Options] → [Setup]

→ [Page 3] → [Signal Select RGB2] → [Scart].

SCART is a standard European audio-visual connector for TVs, VCRs and DVD players. It is also referred to as Euro-connec- tor.

NOTE: The ADP-SC1 SCART adapter is obtainable from your NEC dealer in Europe. Contact your NEC dealer in Europe for more information.

Connecting an External Monitor

			AUDIO	DVI
AUDIO OUT			RGB 1
			SLOT 1	SLOT 2
L/MONO			L/MONO
R		AUDIO	R
	RGB 2		R/Cr
	RGB OUT		G/Y
			B/Cb
VIDEO		S-
			RGB OUT
			V
L/MONO	L/MONO
R		R

USB A	USB B	PC CARD
	PC CONTROL		LAN
	IN
			REMOTE 1
	OUT
	SC TRIGGER		REMOTE 2
		IN	OUT
			AC IN

Audio cable

(not supplied) RGB signal cable

(not supplied)

To mini D-Sub 15-pin connec- tor on the projector.

LINE IN

Audio cable (not supplied)

PHONE

You can connect a separate, external monitor to your projector to simulta- neously view on a monitor the RGB analog image you're projecting. To do so:

1.Turn off the power to your projector, monitor and computer.

2.Use a 15-pin cable to connect your monitor to the RGB OUT (Mini D-Sub 15 pin) connector on your projector.

3.Turn on the projector, monitor and the computer.

RGB signal cable (not supplied)

To mini D-Sub 15-pin connec- tor on the projector.

NOTE:

•The RGB OUT connector outputs an RGB signal during idle mode (See page 8- 15). When the projector goes into idle mode, the image on an external monitor disappears for a moment. Note that the RGB OUT connector will not output an RGB signal during Standby mode.

•When the projector is in the Idle mode, the image may not be correctly dis- played while the cooling fans are running immediately after turning on or off the power. Note that the RGB OUT connector will not output an RGB signal during Standby mode.

•Daisy chain connection is not possible.

2-14