Avaya CMC1 Install and Wire Telephone Power Supplies, Install 26B1 Selector Console Optional

Install and Wire Telephone Power Supplies

Dual Wiring of 2-Wire and 4-Wire Endpoints

Do not simultaneously wire a 2-wire and 4-wire endpoint to the same equipment location in an MDF, even though they connect to different colored wire pairs. The system uses separate circuit packs to interface 2- and 4-wire endpoints, and none are capable of interfacing both.

Install 26B1 Selector Console — Optional

To install a 26B1 selector console:

1.Connect the supplied 3-foot (0.9 m) D8AC cable to the modular jack on the bottom of the 26B1 Selector Console.

2.Route the cable to the attendant console and connect to the DXS/BLF jack.

3.Attach labels according to the Attendant Console form.

4.Administer the console using Administrator’s Guide for Avaya Communication Manager.

Administer IP Stations and Trunks

For complete information on administering IP stations and trunks, see Administrator’s Guide for Avaya Communication Manager.

Install and Wire Telephone Power Supplies

This section provides information and wiring examples of installation procedures for various telephone and console power supplies. These are examples only and actual wiring procedures may vary at each site.

The power is provided to telephones or consoles either locally or centrally.

Centrally located power supplies include

●1145B2 Power Supply on page 96

●1152A1 Mid-Span Power Distribution Unit on page 106

●P333T-PWR Power over Ethernet Stackable Switch on page 110 Local power supplies include

●1151B1 and 1151B2 Power Supplies on page 113

Issue 10 June 2005 93