Avaya CMC1 manual Monitor download progress

Upgrade Firmware on Programmable Circuit Packs

3.Press Enter to submit the schedule.

If you set the Schedule Download field to n, the download starts as soon as you submit the schedule.

Note:

If you are scheduling firmware downloads for a circuit pack that is designated as primary/secondary sync (timing) source (for example, TN464GP/HP), this procedure automatically redesignates a local timing source during the download. After the download is complete and the circuit pack is returned to service, the procedure designates the original circuit pack as the timing source.

Note:

The target circuit packs are automatically removed from service while the firmware is downloaded to them and automatically returned to service after the download is completed. While a circuit pack is removed from service, any active calls through that circuit pack are dropped.

Note:

An error message asking you to use the command, test firmware download, means that there was a problem with a previous firmware download. Run the test before proceeding. Go to Testing firmware download on page 246.

! CAUTION:

Unless the Remove Image File After Successful Download field is set to y, the ftplogin and ftppassword remain on the TN799DP or TN799C (C-LAN) and TN2501AP (VAL) circuit packs either until they are reset or until you type the disable filesystem board UUCSS command.

4.If the download is scheduled for later, ensure that the download will run as you intend by testing the firmware download. Go to Testing firmware download on page 246.

Monitor download progress

Check the progress of a firmware download with the following procedure.

Issue 10 June 2005 243