Avaya CMC1 manual Adding or Removing Hardware

Adding or Removing Hardware

3.Check the Date and Timestamp fields to determine whether to revert back to a previous image.

In the following example, we are reverting back to Image 2, because it has the older date and time stamp.

Note:

In most cases, the image with the more recent date and time stamp is the new firmware image file.

4.Type set boot-image board UUCSS image 1 2 and press Enter. Example: set boot-image board 1C07 image 2

The system responds with Command Successfully Completed.

5.Type get boot-imageUUCSS and press Enter to check the status of the firmware images on the target circuit pack.

get boot-image 1C07
		DISPLAY FIRMWARE IMAGE(S)
	Image 1	Image 2
Board Type: TN2501		TN2501
FW Vintage:	02	01
HW Signature:	02	02
Suffix:	A	A
Date:	03/02/02	03/02/01
Timestamp:	10:30:50	12:42:18
CRC Checksum:	Good	Good
Active Image:	Yes	No
Reboot Image:	No	Yes

Note that the values in the Reboot Image field have changed.

Note:

If a TN799C/DP C-LAN or TN2305 VAL circuit pack, reseat them to activate the new firmware image. Go to Reseat VAL circuit pack on page 245.

248 Installation, Upgrades and Additions for Avaya CMC1 Media Gateways