Avaya CMC1 manual Administration, ESM installation

Install multimedia call handling (MMCH)

Figure 101: Typical multimedia call handling ESM connections

Figure notes:
1.	Port B Y-cable connector to a TN787	5.	D8W cord connected to 357A
	multimedia interface (MMI) circuit pack		adapter S/B port 8
2.	Port A Y-cable connector to a TN2207 PRI	6.	Expansion service module
	circuit pack		(ESM)
3.	25-pair Y-cable	7.	Port B on compatible primary
4.	357A adapter		rate interface (PRI) card

ESM installation

Use the following procedure and Figure 101 to connect to the ESM equipment:

1.Install the TN2207 primary rate interface (PRI) circuit pack and the TN787F/G/H/J/K multimedia interface (MMI) circuit pack in the port carrier.

2.Record the circuit pack locations.

3.Connect the ESM Y-cable as shown.

Administration

1.Enter list configuration all, and a list of the installed carriers, circuit packs, and ports appears.

2.Record the location (board number) of the new circuit packs and verify that all other required circuit packs (refer to ESM installation) are present.

3.Enter add DS1 xxxxx, (where xxxxx is the location of the TN2207 PRI circuit pack recorded in step 2), and the DS1 circuit pack administration form appears.

4.Set the Name: field to ESM DS1

5.Set the Bit Rate: field to 2.048

6.Set the Line Coding: field to hdb3

Issue 10 June 2005 321