Avaya CMC1 manual Place test call, Troubleshooting

Adding or Removing Hardware

7.Set the Signaling Mode: field to isdn-pri

8.Set the Connect: field to pbx

9.Set the Interface: field to network

10.Set the Country Protocol:field to 1

11.Set the Protocol Version:field to a

12.Set the CRC?:field to y

13.The Idle Code default is 11111111.

14.The DCP/Analog Bearer Capability default is 3.1 kHz.

15.Set the MMI Cabling Board: field to xxxxx (where xxxxx is the location of the TN787F/ H/J/K MMI circuit pack recorded in step 2). This must be the slot for port B of the Y-cable.

16.The MMI Interface: field ESM appears.

17.Enter add signaling-group next and the signaling-group form appears.

18.Change Associated Signaling: field to y.

19.Change Primary D-Channel Port: field to xxxx17 (where xxxx is the address of the

TN2207 PRI circuit pack, for example: 1B0517).

20.The Max Number of NCA TSC: default is 0.

21.The Max Number of GA TSC: default is 0.

22.Trunk Group for NCA TSC: ____ (leave blank)

23.Trunk Group for Channel Selection:____ (leave blank)

24.Logoff the terminal and then log back on the terminal to view your changes.

Place test call

Place multimedia data-conference call to an endpoint with known video capability to test the esm function.

Troubleshooting

To determine ESM link status enter the following commands from the system administration terminal:

1.Status esm

2.Status signaling-group

3.List MMI

322 Installation, Upgrades and Additions for Avaya CMC1 Media Gateways