Avaya CMC1 manual Test the External Connection to the LAN, Ping Results, Medpro Pass

Adding or Removing Hardware

-Set the Net Region field to 1 unless you are given a different number.

-Set the Enable Eth Pt field to y

7.Press Enter to save the information and effect the new settings.

Refer to the Administration for Network Connectivity for Avaya Communication Manager for more information on these administration steps and for the steps to administer IP Softphones and H.323 trunks.

Note:

The administration of the TN2302AP is the same as that for the TN802B.

Test the External Connection to the LAN

To test the external IP connections, ping the C-LAN or IP Media Processor server and ping a known computer connected to your network. If everything is configured correctly, the Result column on the Ping Results screen reads pass. If it reads abort, verify the IP-address information and check the connectivity, including the cabling.

To test the external connection to the TN799DP and 2302AP circuit packs:

1.Type ping ip-addressnnn.nnn.nnn.nnn board UUCSS and press Enter. The variable nnn.nnn.nnn.nnn is the IP address of the TN2302AP IP Media Processor and UUCSS is the cabinet, carrier, and slot of the TN2302AP IP Media Processor.

ping ip-address 192.168.10.21
		PING RESULTS
End-pt IP	Port	Port Type	Result	Time(ms)	Error Code
192.168.10.21	01A13	MEDPRO	PASS	10	1124

2.Type ping ip-address nnn.nnn.nnn.nnn board UUCSS and press Enter. The variable

nnn.nnn.nnn.nnnis the IP address of the customer’s gateway and UUCSS is the cabinet, carrier, and slot of the TN2302AP IP Media Processor.

3.Type ping ip-address nnn.nnn.nnn.nnn board UUCSS and press Enter. The variable

nnn.nnn.nnn.nnnis the IP address of another computer beyond the gateway and UUCSS is the cabinet, carrier, and slot of the TN2302AP IP Media Processor.

The TN2302AP IP Media Processor is now installed in the carrier and connected to the IP network.

286 Installation, Upgrades and Additions for Avaya CMC1 Media Gateways