Avaya CMC1 manual Administer the IP connections, List configuration board

Add Integrated Announcements/TN2501AP

Note:

If the TN2501AP or TN750 circuit packs are at the system limit and you insert a VAL circuit pack, the red LED on that circuit pack stays on, indicating that the system does not accept it.

3.Connect the Backplane Adapter (Figure 85) to the Amphenol connector on the back of the switch cabinet, corresponding to the TN2501AP circuit pack slot.

4.Connect the LAN cable to the RJ-45 connector on the Backplane Adapter.

Administer the IP connections

Use the following commands to administer the IP connections of the announcement circuit pack.

list configuration board

To ensure that the switch recognizes the TN2501AP circuit pack after it is latched in the carrier slot.

1.At the SAT, type list configuration board board-locationand press RETURN. The System Configuration report appears.

Figure 86: System Configuration screen (list configuration board)

list configuration board 1c08									SPE A
		SYSTEM CONFIGURATION
Board						Assigned Ports
Number	Board Type	Code	Vintage	u=unassigned t=tti p=psa
01C08	VAL-ANNOUNCEMENT	TN2501AP HW00 FW001 01 02				03 04 05 06 07				08
				09	10	11	12	13	14 15	16
				17	18	19	20	21	22 23	24
				25	26	27	28	29	30 31	32
				U

Command successfully completed

2.Verify the following field values:

●Board Type shows VAL-ANNOUNCEMENT

●Code is TN2501AP

Issue 10 June 2005 263