Avaya CMC1 manual Data module settings, Adding a data module

Set Up System Access

Data module settings

To set the data module for a PC connection:

1.Cycle the power to the data module. The unit performs a self test and displays its operating mode.

2.Observe the display.

a.If the display reads DCE mode, proceed to the next section.

b.If the display reads DTE mode, complete the following steps:

1.Remove the power cord from the unit.

2.Remove the cover from the top rear of the unit.

3.Remove the mode select circuit board and turn it around.

4.Replace the cover.

5.Connect the power cord.The unit performs a self test.

Note:

The power LED must be steady on. If the power LED is blinking, the data module is not communicating with the Avaya CMC1 Media Gateway. Check the wiring at the MDF, wall jacks, and data module.

Adding a data module

To add the data module for a PC connection:

1.Type add data-module number or add data-module next.

2.In the Type field, type pdm and press Enter.

3.In the Port field, type the location of the digital line circuit pack connected to the data module (for example 01A1503).

4.If system access ports and hunt groups have not been set up, set them up. Refer to Administrator’s Guide for Avaya Communication Manager.

Issue 10 June 2005 71