Avaya CMC1 manual Typical signaling wideband configuration

Install wideband endpoints

Figure 98: Typical signaling wideband configuration

POWER	AUX PORT COM PORT	MODEM	NETWORK
			DTE

cydf047 PDH 091396

Figure notes:

1.Wideband endpoint (wire per manufacturer)

2.To DS1/E1 circuit pack

3.Optional channel service unit (CSU)

4.103A or modular wall jack

5.Part of main distribution frame

6.Bandwidth controller

7.H600-307 cable to DTE connector on

CSU

8.Distance limit depends on cable type and bandwidth controller type

9.A25D 25-pair cable (male-to-male)

The bandwidth controller connects directly to the wideband endpoint. The controller typically installs near the endpoint where they directly connect (usually within a few feet of each other).

●For non-CSU installations, cross the transmit and receive lines so a transmit signal from the DS1/E1 circuit pack connects to the receive connection on the bandwidth controller and a transmit signal from the bandwidth controller connects to the receive connection on the DS1/E1 circuit pack.

●For CSU installations, cross the transmit and receive lines between the CSU and the bandwidth controller.

Issue 10 June 2005 317