Avaya CMC1 manual Install the circuit packs

Add IP Solutions

Install the circuit packs

To install the TN799B/C and 2302AP circuit packs:

1.If replacing the TN799 circuit pack, install the TN799B/C circuit pack in the slot vacated by the TN799 circuit pack.

2.For convenience install the TN2302AP circuit pack in the rightmost slot vacated by the TN802B and where the adapter is connected to the corresponding backplane connector. The other 2 slots are now available for other circuit packs.

When you plug in the TN2302AP IP Media Processor, the circuit pack starts to boot. The RED LED stays on until an IP address is assigned to the circuit pack.

3.Type list configuration all and press Enter to verify that the system recognizes the TN2302AP circuit packs.

Administration

To administer the TN799B/C and 2302AP circuit packs:

1.Administer the TN799B/C C-LAN, if necessary. Refer to the Administration for Network Connectivity for Avaya Communication Manager.

2.Administer the IP Media Processor, which is usually done remotely. Call your service representative to start the process.

3.Complete the administration and testing. Refer to Initial Administration Steps for C-LAN and IP Media Processor on page 284 and Test the External Connection to the LAN on

page 286.

Issue 10 June 2005 291