c Optional Lens Installation
This section describes how to install the lens.
See page
*Determine the optional lens to be used to obtain a desired projection distance. There are nine optional lenses available: GT12ZLB, GT13ZLB, GT19ZLB, GT20ZL, GT24ZLB, GT34ZLB and GT48ZLB (Zoom lens)
GT06RLB and GT10RLB (Short throw
*Press the power button (ON/STAND BY) on the projector or POWER OFF button on the remote control for a minimum of two seconds to turn off the power, wait 90 seconds (2 minutes in the optional extended life lamp GT60LPS) for the cooling fan to stop, turn off the main power switch then disconnect the power cable.
Check that the projector has cooled off sufficiently before proceeding.
CAUTION
*The projector and lens contain
*Do not touch the lens surface. Doing so can degrade the optical performance.
For installing GT10RLB, GT13ZLB, GT19ZLB, GT20ZL, GT24ZLB, GT34ZLB and GT48ZLB
Preparation: Tools needed for installation:
A hexagonal driver and
1.Remove the lens hood cap and lens hood. q Remove the lens hood cap.
w Loosen and remove the 2 screws on the lens hood using the hexagonal driver. e Remove the lens hood by pushing down and pulling the top toward you.
Lens hood
Lens hood cap
S- | |
| VIDEO B/Cb |
| H/ |
L/MONO | HV |
L/MONO | V |
R |
|
R |
|
1
3
USB( |
|
|
|
MOUSE/HUB) | USB(PC) |
| 2 |
|
| PC | CARD |
|
|
| |
PC | CONTROL |
| 1 |
|
|
| |
| IN |
| LAN |
|
|
|
SC | OUT | REMOTE |
|
TRIGGER |
| ||
|
| 1 |
REMOTE2
IN
OUT
AC IN
3
2
2. Attach a
q Remove the shipping tape on the back of the lens hood. w Insert the
1
2
Shipping tape
Insert the
Hole | Align the holes on | |
the right. | ||
|