8. Using
Advanced
IP Address
An IP address can be automatically assigned to this projector by your DHCP server. If your network does not automatically assign IP address, ask your network administrator for an ad- dress, and then register it manually.
Automatic .... Automatically assigns an IP address to the pro-
jector from a DHCP server.
Manual ........ Provides a space for you to register the IP ad-
dress or subnet mask number obtained from your network administrator.
IP Address ... Set your IP address. Press to display the soft- ware keyboard and type in 12 numeric charac- ters.
Subnet Mask Set your subnet mask number. Press to dis- play the software keyboard and type in 12 nu- meric characters.
Gateway ...... Set the default gateway of the network connected
to the projector. Press to display the software keyboard and type in 12 numeric characters.
Checking this box will make the set default route valid.
When data is sent from the LAN card, the trans- fer location will be searched according to the pre- viously set routing information; however, when the transfer location has not been found as a re- sult of the search, the data will be sent to the device that holds the IP address set here. The IP address that is set here must be one that can be identified by a search of the routing information.
DNS Configuration
.................... Type in the IP address of the DNS server on the
network connected to the projector.
12 numeric characters are used. Domain Name
.................... Type in domain name of the network connected
to the projector. Up to 60 alphanumeric charac- ters can be used.
Network Type (required for wireless only)
Mode:
Select communication method when using wireless LAN.
Infrastructure
.................... Select this option when communicating with one
or more equipment connected to the wireless or wired LAN network via an access point.
802.11 Ad Hoc
.................... | Select this option when using the wireless LAN |
| to communicate with a computer in a |
| correspondence. This is a method that meets the |
| IEEE802.11 wireless standard. |
Ad Hoc | Select this option when using the wireless LAN |
| to communicate with a computer in a |
| correspondence. |
Easy Connection
.................... This allows you to easily set up wireless LAN
connection. See the Software Utility Installation section for more information.
See chapter 6 “Using the Projector in a Network”.
SSID (Network name):
Enter an identifier (SSID) for wireless LAN. Communication can be done only with equipment whose SSID matches SSID for your wireless LAN. Up to 32 alphanumeric characters can be used (Case sensitive).
NOTE: To disable SSID, select a space (null) or "ANY"(All caps).
Channel:
Set this option when selecting [802.11 Ad Hoc] or [Ad Hoc] in [Mode].
Select a channel number from the
NOTE: Channels in the
TX rate:
Select a wireless transmission speed. Normally leave it as Au- tomatic.
Try another transmission speed when the connection fails.
