NEC LT180 manual Part Names of the Projector

1. INTRODUCTION

Part Names of the Projector

Controls (See page E-4)

Speaker

Ventilation (inlet)

Remote Sensor (See page E-9)

Focus ring

(See page E-25)

Zoom lever (See page E-24)

Lens

Adjustable Tilt Foot Lever (See page E-24)

TCELES

YB D

NATS/NO

SUT	RE	WOP
	ATS
PMAL

S-VID

EO IN

L/mon

o

Cb/Pb

UDIO

IN

Y

A

R

VIDEO

IN

Cr/P

r

NT

IN

ONE

COMP

UTER

IN

AUDI

O IN

COMP

TOR

OUT

AC

IN

MONI

CONT

ROL

Ventilation (outlet)

Terminal Panel (See page E-5)

AC Input

Connect the supplied power cable's two-pin plug here, and plug the other end into an ac- tive wall outlet. (See page E-19)

Lens Cap

Adjustable Tilt Foot (See page E-24)

Lamp Cover (See page E-45)

Main Power Switch

When you plug the supplied power cable into an active wall outlet and turn on the Main Power, the POWER indicator turns orange and the projector is in standby mode. (See page E-20)

ON/STAND BY

	LAMP
PO	STATUS
	WER

SOURCE

SELECT

Lamp Cover Screw (See page E-45)

Ventilation (inlet)

Built-in Security Slot ( ) *

Adjustable Rear Foot (See page E-23)

*This security slot supports the MicroSaver® Security System. MicroSaver® is a registered trademark of Kensington Microware Inc. The logo is trademarked and owned by Kensington Microware Inc.

E-3