3.PROJECTING AN IMAGE (BASIC OPERATION)
3.PROJECTING AN IMAGE (BASIC OPERATION)
This section describes how to turn on the projector and to project a picture onto the screen.
Turning on the Projector
NOTE:
•The projector has two power switches: a main power switch and an ON/STAND BY button.
•When plugging in or unplugging the supplied power cable, make sure that the main power switch is pushed to the off (O) position. Failure to do so may cause damage to the projector.
To turn on the main power to the projector, press the Main Power switch to the on ( I ) position. The POWER indicator will light orange.
LAMP
STATUS
POWER
Before you turn on your projector, ensure that the computer or video source is turned on and that your lens cap is removed.
Only after you press the ON/STAND BY button on the projector cabinet or POWER ON button on the remote control for a minimum of 2 seconds will the POWER indicator turn to green and the projector become ready to use.
Cabinet controls
Remote control
OFFON
POWER 
LAMPKEYSTONE
STATUS
POWER
UP
SOURCE | SELECT |
DOWN
ON/STAND BY
AUTO
ADJ.
MENU
Standby | Blinking |
LAMP | LAMP |
STATUS | STATUS |
POWER | POWER |
Steady orange light | Blinking green |
| light |
See page
Power On
LAMP
STATUS
POWER
Steady green
light
NOTE: The POWER and STATUS (LED) indicators blinking green at the same time indicates the main power was interrupted during previous operation. Wait for 60 seconds (cooling period) to see if the lamp turns on by itself.
