(2)SERVICE LED (orange)
The SERVICE LED goes on orange if an error occurs in the additional disk enclosure.
The LED is off while the disk enclosure operates normally.
(3)Disk drive/dummy tray
Disk drive: | Contains a hard disk drive (HDD) with the dedicated tray. |
Dummy tray: | Contains only the dedicated tray with no hard disk drive. |
*The additional disk enclosure
*The disk drives installed in the disk enclosure are dedicated to the FC loop at 2Gbps.
A mixture of 1Gbps and 2Gbps disk drives is not permitted. Do not install any 1Gbps disk drives in the disk enclosure.
The following measures are adopted to prevent insertion of a 1Gbps disk drive:
A)A 1Gbps disk drive cannot go into the position where a 2Gbps disk drive is locked.
B)The ejector color is different.
(4)HDD READY LED (green)
The HDD READY LED is lit green while the disk drive operates normally. The LED blinks when the disk drive transfers data.
The HDD READY LED blinks during the
(5)HDD FAULT LED (orange)
The HDD FAULT LED goes on at the occurrence of an error in the disk drive. The LED is off while the disk drive operates normally.
(6)Ejector
The ejector is used to install or remove the disk drive or dummy tray. In the normal operation status, the ejectors fix disk drives or dummy tray to the additional disk enclosure.
When inserting the disk drive into the disk enclosure, push it as far as it will go and then lock the ejector.
Incorrect insertion may cause malfunction.
- 9 -
