(2)Connection of power cord

Insert the provided power cord or the NEC-specified power cord to the plug on the power supply of the disk enclosure.

When connecting the power supply of the disk enclosure, push down the power cord stopper toward the left, insert the power cord, and then secure the power cord by firmly fitting the power cord stopper into the receptacle of the power cord.

(3)Connection of power plug

Insert the plug of the provided power cord or the NEC-specified power cord to an AC outlet. Because the plug has an earth pin, use an AC outlet with earth terminal for the connection as shown in the figure below.

While the additional disk enclosure can accept the power of 100 - 240 VAC (50/60 Hz), the power cord coming with the additional disk enclosure can only accept 100 - 120 VAC. Use 100 - 120 VAC (50/60 Hz) when the attached power cord is used. Using power of different voltage may cause electric shock, smoke, and/or fire to occur.

- 26 -

Page 40
Image 40
NEC NF2300-SE41E manual