Base Module
(Description) |
|
| |
Description |
|
| Description |
No. |
|
| |
|
|
| |
(a) |
| Allows to choose environmental data formats from page format of 24 lines each | |
| or online format. | ||
|
| ||
|
| Indicates the states of the Power Bay within the cabinet. | |
|
| If an alarm condition exists, this line is prefixed with an asterisk (*). | |
|
| state |
|
|
| ON | : A DC power (48V) is applied to the components inside the cabinets. |
|
| OFF | : No DC power (48V) is applied to the components inside the cabinets. |
(b) |
| : The Power Bay itself is not existent (not visible from the iSP). | |
| DPSx |
| |
|
|
| |
|
| (blank) | : Indicates the normal state. |
|
| ALARM | : Indicates an alarm state. |
|
| : Indicates that the DPS is not existent (not visible from the iSP). | |
|
| NORESP : Indicates that the DPS is existent but not visible from the iSP. | |
|
| No DPS exists on a | |
|
| Shows the states of the fans located in the CPU cage or main chassis in the | |
|
| Main Cabinet. | |
|
| If an alarm condition exists, this line is prefixed with an asterisk (*). | |
(c) |
| : Indicates that no fan exists. | |
| ALARM | : Indicates an alarm state. | |
|
| ||
|
| low | : Indicates that the fan is running at low speed. |
|
| HIGH | : Indicates that the fan is running at high speed. “HIGH” will appear if |
|
|
| any cause of |
(d) |
| Press <ENTER> to go to the next page. | |
(e) |
| Power On/Off state of the CELL and XBX Cards in the CPU cage or main chassis | |
| within the Main Cabinet. | ||
|
| ||
|
| Power and fan states within the PCI Bay. | |
(f) |
| If a fan alarm exists, this line is prefixed with an asterisk (*) | |
|
| PCI Bay types (D) and (E) are added for PCID Bay and PCIE Bay, respectively. | |
|
| Temperature detected by the card’s temperature sensor is shown here. If a | |
|
| temperature sensor failure exists, an asterisk (*) is shown in place of a | |
|
| temperature readout. | |
|
| If a temperature alarm exists, the pertinent line is prefixed with an asterisk (*) | |
|
| The threshold information | |
|
| “FAN” gives the temperature thresholds where fan speed is switched from low to | |
|
| high and vice versa. | |
|
| The values on the right side give the threshold to switch from low to high speed, | |
(g) |
| and those on the left side from high to low speed. | |
| “IPMI” gives the threshold over which temperature information is reported to the | ||
|
| ||
|
| software through the IPMI interface. | |
|
| “ACPI” gives the threshold over which temperature information is reported to the | |
|
| software through the ACPI interface. | |
|
| “S.D.” specifies the temperature threshold for the SPFW to force system shut | |
|
| down. If AIR FLOW IN (intake temperature) reaches the S.D. theshold, all the | |
|
| running partitions are forcibly shut down. | |
|
| The WARN column on AIR FLOW IN (intake temperature) gives the threshold | |
|
| rejecting to boot currently inactive partitions. | |
