Operation Procedure
2) Example of SP console screen during system startup
<= Enter up and press | Enter |
| ||
|
|
|
| |
This command will bring up the specified partition. | ||||
|
|
| ||
Enter partition number | <= Enter all and press | Enter | ||
|
|
| ||
|
| |||
Execute OK? (y/[n]) y | <= Enter ｙ and press | Enter |
| |
|
|
|
|
|
UP command was accepted. All partitions will run soon.
[iSPyz:INFO.ccc] partition 0 : turning on POWBAY(s)...
[iSPyz:INFO.ccc] partition 0 : turning on XBX_C(s)...
[iSP0m:INFO.ccc] XBX00 SD completed normally.
[iSP0m:INFO.ccc] XBX01 SD completed normally.
：
[iSPyz:INFO.ccc] partition 0 : turning on PCI_BAY(s)...
[iSP0m:INFO.ccc] IOX00 SD completed normally.
:
[iSP0m:INFO.ccc] partition 0 : turning on CELL(s)...
[iSP0m:INFO.ccc] MMX00 SD completed normally.
:
>> SP LOG MESSAGE START (07:6L) <<
11/28/2005 11:31:18
>> SP LOG MESSAGE END <<
[iSP0m:INFO.ccc] partition 0 : handed off the control to BIOS. (DIPSW = 00000000)
Note: When multiple partitions are defined, a particular partition can be selected by entering its partition number instead of entering “all.”
