148
µPD750008 USER'S MANUAL
(3) Serial clock selection
To select the serial clock, manipulate bits 0 and 1 of serial operation mode register (CSIM). The serial
clock can be selected out of the following four clocks:
Table 5-8. Serial Clock Selection and Application (In the Two-Wire Serial I/O Mode)
Mode register Serial clock Timing for shift register R/W and Application
CSIM CSIM Source Masking of start of serial transfer
1 0 serial clock
0 0 External Automatically <1> In the operation halt mode Slave CPU
SCK masked when (CSIE = 0)
0 1 TOUT 8-bit data <2> When the serial clock is Arbitrary-speed
flip-flop transfer is masked after 8-bit transfer serial transfer
completed <3> When SCK is high
10f
X
/26Low-speed
11
serial transfer
(4) Signals
Figure 5-49 shows operations of RELT and CMDT.
Figure 5-49. Operations of RELT and CMDT
(5) Transfer start
Serial transfer starts by writing transfer data into shift register (SIO), provided that the following two
conditions are satisfied:
• The serial interface operation enable/disable specification bit (CSIE) is set to 1.
• The internal serial clock is not operating after 8-bit serial transfer, or SCK is high.
Cautions 1. Setting CSIE to 1 after writing data to the shift register does not start transfer.
2. When data is received, the N-ch transistor must be turned off, so FFH must be
written to SIO beforehand.
When eight bits have been transferred, serial transfer automatically terminates setting the interrupt
request flag (IRQCSI).
SO latch
RELT
CMDT