NEC PowerMate VT 300i Series Release Notes A-5
Installing LapLink Application Not Supported
The LapLink application included on the NEC Application and Driver CD is not
supported. This version of LapLink can cause problems when installed. When
released, a new version w ill be availa ble on the N E C CSD website
(http://www.nec -computers.co m). On the website, select Service & Support
and then choose PowerMate.
Installing PartitionMagic
Install PartitionMagic™ files from the NEC Application and Driver CD. Se lect
the PartitionMagic software from the Applications tab in the Inst a llation utility
menu. The utility loads files from the NEC Application and Driver CD to
C:\Program Files\PowerQuest\PartitionMagic4. You can find setup and
documentation files in the following folders:
Btmagic
Diskette
Setup
Userinfo.
If the PartitionMagic setup program asks you for a serial number, enter the
following nu mb er :
PM400ENOEMCD-673785
See the documentation in the Userinfo folder for information about using
PartitionMagic, BootMagic™, and the recovery diskette program. Reading the
Userinfo files requires the Adobe® Acrobat reader. Insta ll the Adobe Acrobat
reader from the NEC Application and Driver CD. Select the Adobe Acrobat
software from the Applications tab. To load the reader, run Ar32e301.exe from
the C:\Acrobat3 folder.
Note:
If you are installing BootMagic in a system with
the Windows NT operating system, see “Installing
BootMagic in a System with Windows NT” at the end of this
document.
Getting CD-ROM Support in Command Prompt Only Mode
CD-ROM support is not available when you select F8 at the “Starting Windows
9x” prompt and select the Command Prompt Only option. To initiate
CD-ROM support in the Command Prompt Only mode, run DOSSTART.BAT
which is located in the C:\WINDOWS directory.