NEC PowerMate VT 300i Series Release Notes A-17
2. Configure BootMagic.
If you want to use BootMagic:
Click the ENABLE BOOTMAGIC button. The BootMagic menu appears
during the next bootup sequence and lets you select Windows NT as the
operating system.
If you do not want to use BootMagic:
Do not select the ENABLE BOOTMAGIC button. The Boot Magic menu
does not appear at bootup.
3. Select SAVE/EXIT in the BootMagic Configuration box to complete the
configuration process. Either choice, to enable BootMagic or to not enable
BootMagic, requires the SAVE/EXIT selection.
!
CAUTION
To correctly complete the BootMagic configuration, you must
select SAVE/EXIT from the BootMagic Configuration box,
even if you do not want to use BootMagic. Omitting this step
results in an error message.
Correcting the BootMagic Configuration
If you installed BootMagic in a system with the Windows NT operating system
and the installation resulted in an error message, use the following procedure to
correct the configuration information.
1. In the Windows Start menu, select Programs, PowerQuest BootMagic,
and BootMagic Configuration. The BootMagic Configuration box appears.
Nothing should be listed under the MENU NAME heading in the center of
the box.
2. Click ADD. The “Boot magic Add OS” box appears. This is the only option
listed and it is already highlighted.
3. Click OK. Click OK aga in. The main BootMagic Configuration screen
appears with “Windows NT” listed under MENU NAME.
4. Check the BootMagic configuration.
If you want to use BootMagic:
Click the ENABLE BOOTMAGIC button. The BootMagic menu appears
during the next bootup sequence and lets you select Windows NT as the
operating system.
If you do not want to use BootMagic:
Do not select the ENABLE BOOTMAGIC button. The Boot Magic menu
does not appear at bootup.