3-8 Disasse mbl y and Reassembly
Expansion Board Removal
Remove any in s t alled expa nsion boar d (s) as follows .
1. Remove the left side cover (see “Removing the Left Side Cover” earlier in
this se ctio n).
2. Label and disconnect any cables connected to the expansion board.
3. Remove and save the screw securing the board to the support bracket.
4. Pull the expansion board out of its connector and expansion slot. Set the
board on an antistatic surface or store in an antistatic bag.
Removing an Expansion Board
A – Screw C – System Board
B – Expansion Board
5. Install a new board or, if not installing a board, install the previously
removed slo t cover.
6. Place the slot cover over the slot and secure it with the slot cover screw.
7. Replace the left side cover (see “Replacing the Left Side Cover” earlier in
this se ctio n).