2-8 System Configuration
Lite-On 32X CD-ROM Drive Jumper Settings
The factory settings for the jumpers on the Lite-On 32X CD-ROM drive are
shown in the following table. The drive is set as the master device on the
secondary channel. Specifications for the CD-ROM drive are included in
Section 9.
Lite-On 32X CD-ROM Drive Jumper Settings
Jumper Jumper Pin Settings
Cable Select (CS) Disabled, pins open (factory default).
Enabled, pins jumpered.
Slave Presen t (SL) Disabled, pins open ( f actory defa ul t).
Enabled, pins jumpered.
Master Select (MA) Enabled, pins jumpered (factory default).
Disabled, pins open.
Zip Drive Jumper Settings
The factory settings for the jumpers on the Zip drive are shown in the following
table. The settings description applies when looking at the back of the drive,
with the IDE connector to the left of the jumper block. The drive is set as the
slave device on the primary channel. Specifications for the Zip drive are
included in Section 9.
Zip Drive Jumper Settings
Jumper Jumper Pin Settings
Drive 0 Selec t (Master Dri ve Select) Right t wo pin sets jum pered.
Drive 1 Selec t (Slave Driv e Select) Right-most pi n set jumpered .
Cable Select Mode All three pi n sets jumper ed .
Tape Backup Unit Jumper Settings
The factory settings for the jumpers on the tape backup unit are shown in the
following table. Specifications for the unit are included in Section 9.
Tape Backup Unit Jumper Settings
Jumper Jumper Pin Settings
Cable Select (CS) Not used (pin s 1-2 open).
Master Device (DS) Enabled, DS (pins 5-6) jumpered.
Disabled, DS (pins 5-6) o p en (factory d ef ault).
Slave Devic e (SL) Disabled, SL (pins 3-4) op en (factory d efault).
Enabled, SL (pins 3-4) jumpered.