NetComm Gateway Series manual Transit Call Control

Transit Call Control

If you wish to restrict a general user (one who is not required to enter the PIN code) to local calls only and prohibit him/her from making long-distance calls started with a prefix “0”, do the following steps:

1.Enable the Outbound Call Control function,

2.Set the PIN code for Outbound Level 5 to blank,

3.Set the Long-Distance Control Table to correspond with the Outbound Level 5 to prohibit making any call with the prefix “0”.

NOTE: Transit Call Control is effective when it cooperate with Long-Distance Control Table.

•Inbound Call Control: Determines when users make a phone call from a PSTN to Gateway FXO whether or not they check the inbound PIN code while placing the phone call to VoIP network only effective for incoming calls calling from a PSTN trunk.

•Outbound Call Control: Determines when users utilize the Gateway FXO interface to divert to PSTN network whether or not they check the outbound PIN code only effective for outgoing calls being diverted to a PSTN Trunk.

•PIN Code: Enter the PIN code (4-6 digits or leave blank. A blank indicates no PIN code is required at this level. Generally, the PIN at level 5 can remain blank to simplify the phone number.)

•Enable: Enables the PIN code at each level.

•Privileges: The level is divided into 0~5 (The levels are in descending order; 0 stands for the highest authority and 5 stands for the lowest.)

SmartVoice Gateway(s) User Guide	47
YML832 Rev2