Management
DRAFT
Copyright Nokia Telecommunications Oy
NTC C33539002SE_A0 5-87
Pinhole settings
Pinhole settings are used to configure static entries to NAPT table. It
allows the configuring of servers, such as Web-HTTP servers, to LAN
which are visible via the WAN interface in cases where NAPT/address
mapping is enabled. The settings affect the whole system.
Note If you have a Web server in LAN make sure that it has a
different port number than M10’s integral W eb server .
You can change the M10’ s W eb server port through the
integral server settings.
Command Configure pinhole
Description Configures pinhole.
Syntax set pinhole item [entry_number] external-port-start
[port_number] external-port-end [port_number] protocol
[tcp | udp | icmp | pptp] internal-ip [ip_address] internal-
port [port_number]
Arguments The entry_number argument defines the unique pin-
hole entry number. The sequential values starting from
0 are accepted. The external-port-start spec-
ifies the start of the external port range. The exter-
nal-port-end specifies the end of the external port
range. Together the external port arguments define the
available range of allowed external ports. The proto-
col argument specifies the protocol. The internal-
ip argument specifies the IP address of the server lo-
cated in LAN and the internal-port argument its
port. Valid values for port_number are 0 – 65535.
Example m10> set pinhole item 1 external-port-
start 80 external-port-end 80 protocol
tcp internal-ip 192.168.1.180 internal-
port 80