Nokia M10, T66160 - page 97

Nokia M10 User’s Manual
DRAFT
 Copyright Nokia Telecommunications Oy NTC C33539002SE_A0
5-48
ATM settings
You can enable ATM over ADSL operation and configure up to eight
ATM channels into use. You can select between five different ways to
encapsulate your payload in an ATM channel. You can also fine tune
the physical layer parameters of the ATM channel. See also DMT
(ADSL) settings on page 5-78.
Command Enable/disable ATM
Description Enables/disables the use of ATM on the ADSL link. Dis-
abling ATM forces M10 to work in a frame mode on the
ADSL link.
Syntax set atm option [on | off]
Arguments The argument enables/disables ATM.
Example m10> set atm option on
Command Set ATM cell header of an empty cell
Description Defines the ATM cell header of an empty (idle) ATM cell
as an 8-bit variable. This command affects the low-level
functionality of the ATM physical layer link and usually
you do not have to change this setting.
Syntax set atm cell ehead [0xbbbbbbbb]
Arguments ADSL standard value is 0x00000001 or 0x00000000
depending on the DSLAM. Nokia B20 requires the
value 0x00000001.
Example m10> set atm cell ehead 0x00000001
Command Set payload content of an empty cell
Description Defines the payload content of an empty (idle) ATM cell
as an 8-bit variable. This command affects the low-level
functionality of the ATM physical layer link and usually
you do not have to change this setting.
Syntax set atm cell epayload [0xbbbbbbbb]
Arguments ADSL standard value is 0x6A6A6A6A.
Example m10> set atm cell epayload 0x6A6A6A6A