Nokia M10 User’s Manual
DRAFT
Copyright Nokia Telecommunications Oy NTC C33539002SE_A0
5-22
1. Plug the serial cable E64320.01 into the console port behind the
hatch on the Nokia M10 front panel.
2. Connect the other end of the serial cable to the serial port on your
terminal (or terminal emulator) or the serial port of your computer.
3. Turn on the terminal or run the terminal emulator program on your
computer.
Use the following settings to configure your terminal emulation
session:
Setting Value
Speed 9600
Parity None
Data bits 8
Stop bits 1
Duplex Full
Flow control None
The console interface uses the same command line interface as the
telnet interface.
Logging in
The command line interface login process emulates the login process
for a Unix host. If your Nokia M10 has been assigned an administrator
password, you must enter a username (up to 32 characters) and your
administrator or user password.
Entering your username lets the Nokia M10 record your access; your
username is not used to validate your authorisation. Entering the
administrator password lets you display and update Nokia M10
settings. Entering a user password lets you display (but not update)
Nokia M10 settings.
When you have logged in successfully, the command line interface
lists the username and the security level (admin or user) associated
with the password you entered in the diagnostic log.
Entering commands in Nokia M10 CLI
CLI commands consist of keywords and arguments. Keywords in a
Config command specify the action you want to take or the entity on