Nokia M10 User’s Manual
DRAFT
E Copyright Nokia Telecommunications Oy NTC C33539002SE_A0
5-44
M10 (top)>> set system
Stepping set mode (press Control-X <Enter> to exit)
system
name (”M10”): Kutoja
Diagnostic Level (High): medium
Stepping mode ended
See Chapter 4 for step mode installation examples.
Validating your configuration
You can use the validate command to make sure that your
configuration settings have been entered correctly. If you use the
validate command M10 verifies that all required settings are present
and that the settings are consistent.
M10 (top)>> validate
Error: Subnet mask is incorrect
Global Validation did not pass inspection!
You can use the validate command to verify your configuration
settings at any time. Your M10 automatically validates your
configuration any time you save a modified configuration.
Config command reference
The top level configuration command nodes are listed below:
Dsystem Unit system options
Dpreference CLI preferences
Datm ATM options
Dbncp BNCP options
Dip TCP/IP options
Dlocation Location Manager options
Ddhcp DHCP options
Ddns DNS options
Dbridge Bridge options
Ddmt DMT ADSL options
Dsnmp SNMP options
Dppp PPP options
Dpinhole NAT/NAPT server configuration
Dservers Local integrated server configuration
The sections below explain the commands under each top level
configuration node.