Nortel Networks 5000i Work Table, Monitor and Keyboard, Monitor XE Standalone installationMonitor

slot. Do not connect to the 15-pin connector on the system board.

6.Complete installation of the 50-pin high density ribbon cable - the Camera Controller board to the Hobbes interface connector on the computer.

•One end of this cable is already connected to the scanner's Camera Controller board at J1.

•Connect the other end (free end) to the external connector for the scanner interface (Hobbes) card (P2) on the back of the computer.

7.Complete installation of one 9-pin D cable - the Scanner Controller main board to the Com1 port on the back of the computer.

•One end of this cable is already attached to the scanner's Scanner Controller main board at J9.

•Connect the other end (free end) to the Com1 port on the back of the computer.

Once all computer cabling connections have been made, set down the computer flat on the shelf, coil any extra cabling under the computer shelf, and close the rear panels.

Work Table

The standalone 5000i scanner comes with a { XE "Standalone installation:Work table" }work table. This work table is for the monitor, the keyboard, and the mouse. Instructions for assembling the work table are provided by the manufacturer.

Monitor and Keyboard

Place the monitor, the keyboard, and the mouse on the work table. The monitor, the keyboard, and the mouse need to be cabled to the computer. (See Figure 3-5 for cable locations.)

Monitor{ XE "Standalone installation:Monitor" }

1.Connect the power cord:

•Plug the female end of the power cord into the port labeled AC Outlet on the back of the monitor.

•Plug the other end (male end) into an AC wall outlet or power strip.

2.Ensure that the monitor cable is connected. (See Step 6 under cabling.)

3.Complete installation of the 5 BNC cable - from the bulkhead to the back of the monitor.

•Connect one end of this cable to the bulkhead. Install the cable according to the colors labeled on the bulkhead.

•Connect the other end (15-pin) to the back of the monitor.

Keyboard and Mouse{ XE "Standalone installation:Keyboard and mouse" }

1.Plug the keyboard cable connector into the port labeled KEYBOARD located on the scanner's back panel (bottom and second cutout from the left).

2.Plug the mouse cable connector into the port labeled MOUSE located on the scanner's back panel (bottom and second cutout from the left).

Chapter 3. Computer and Peripherals Installation Page 23